A Perfect Fit, Step by Step

so you can slip the mat over the headrests and bring it all the way down to the seats. This anchors the cover securely, keeping it firmly in position as you complete the setup.

Gently slide the back of the seat cover downward over your seats, then press into the center so it molds naturally to the contours of your seat. Finally, zip the top shut to secure the cover.

Make sure the base cover is positioned correctly, with the rectangular end facing toward the seat.

Follow the product-specific fitting instructions and check the alignment before securing the cover.

With the discs aligned, carefully attach them back to the mounting bracket. Then, slide the assembly through the gap between the seat and floor to place it accurately in your vehicle.

Clip the metal hooks onto the mat’s front strap, then anchor them under your seat. This secures the mat firmly, keeping it from moving around while you drive.

If you choose to fully zip the back cover, mark where the headrest posts go and puncture a small hole to reinstall them. Alternatively, you can simply zip up to the posts.

Repeat the installation process on the opposite front seat. Once done, your front seat covers are fully set up and ready to go!

Position the two side covers with the stripe running vertically down the middle. Make sure the velcro faces inward, align symmetrically on both sides, and press firmly.

Attach the discs, push them through the seat gap, and tuck them tightly in place to prevent shifting.

Tuck the tabs beneath the rear mats into the vehicle trim under the seats. Ensure both sides are securely held.

Fit the plain middle piece over the side covers using the same method. If it blocks your seatbelts, send us your measurements for a free replacement.

Position the rear pieces along the sides of the headrests with the curved edge facing outward. Align precisely and secure using the same anchor discs.

Some vehicles have a small rectangular mount on the rear headrest. If yours does, use the included rectangular piece to anchor the mat in place.

Position the middle back piece (with velcro sides) behind the two side covers. If you want to use your fold-down cup holder, you can detach this piece whenever needed.

Secure the covers using the discs (one disc can hold two straps), and tuck them into the gap between the seat and backrest for a tight fit.

Congratulations on fitting your rear seat covers! Take a moment to make any final adjustments and ensure all fasteners are secure. Your interior is now fully protected and ready to go.